ALFA DECOXY

Clear Epoxy Casting System

Packaging
30kg, 15Kg, 1.5Kg

ALFA DECOXY

Clear Epoxy Casting System

ALFA DECOXY is two components 100% solid room temperature curing, low viscosity epoxy system for clear casting and lamination application. The system is clear, having excellent optical properties with negligible shrinkage on curing. Faster productivity can be achieved, if curing Is performed at higher temperature near to 40°Cng water, then add to concrete mixer & mix for another 2 minutes Place the concrete or apply plaster, as needed. Cure the applied mortar or concrete as per good construction practices. Dosage: 100 ml per 50 kg bag of cement

Features :

The Epoxy casting system ALFA DECOXY offers:
Cure without bubbling or blushing.
Glass like transparent casting with good hardness.
Good wetting properties
High gloss finish
Long potlife
Resistance to water and chemicals

Applications:

Table Top application
Clear casting articles and decorative parts
Handicrafts and decorative arts

Application:

Mix mass should then be poured into a mould. The mould can be hard or made of silicone rubber. Moulding can be carried out by gravity or under vacuum. It does not trap air easily and does not heat up when used properly. Excessive humidity (above ~65%), low daylight and low temperature (less than 20°C) may retard the cure. ALFA DECOXY system may not work effectively in the monsoon season. Ensure ambient material and workshop temperature is between 20°C and 35°C and humidity level below 65%. Filled mould can also be kept under vacuum to achieve air free components. Long potlife Resistance to water and chemicals

Mixing:

Mixing is critical and must be accurate. Take resin and hardener in desired ratios. The combined liquids must be thoroughly mixed, manually or mechanically to completely remove any hasiness or streaks. Scrap the sides and base of the mixing pot before transferring the mix to a desired mould for casting. It is advisable to apply the vacuum to remove air from the mix just prior to pouring into the moulds. It is important to mix small quantity at a time as epoxy systemstend to give exotherm when kept in a mass.